MAC TOOLS MW250 Instrucciones de operaciones descargar pdf (Pagina 60)

TM 5-4310-452-14

3-3. TROUBLESHOOTING SYMPTOM INDEX.

Troubleshooting

Procedure

Page

COMPRESSOR

Air discharge capacity too low ......................................................................................................... 3-4

Oil:

Consumption too high .................................................................................................................. 3-5

Excessive carry-over at air discharge ........................................................................................... 3-4

Level reading erratic .................................................................................................................... 3-5

Overheats........................................................................................................................................ 3-4

ENGINE

Difficult to start ................................................................................................................................ 3-3

Oil pressure too low ........................................................................................................................ 3-3

Overheats........................................................................................................................................ 3-3

Runs backward when turned off ...................................................................................................... 3-4

Unusual amount of smoke from exhaust ......................................................................................... 3-3

Will not start .................................................................................................................................... 3-2

Table 3-1. Operator Troubleshooting Procedures.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

ENGINE

1. ENGINE WILL NOT START.

Step 1. Check to see if fuel tank is empty.

If empty, notify your supervisor.

Step 2. Check for loose or corroded battery terminals.

If loose or corroded, notify your supervisor.

Step 3. Check engine air cleaner restriction indicator.

If red condition is present, clean air cleaner (see paragraph 3-4).

Step 4. Check fuel lines for leaks, kinks, or restrictions.

If leaks, kinks, or restrictions are found, notify your supervisor,

3-2

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 404 405

MAC TOOLS MW250 Instrucciones de operaciones Pagina 60

Comentarios a estos manuales

MAC TOOLS MW250 Instrucciones de operaciones Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura MAC TOOLS MW250