MAC TOOLS MW250 Instrucciones de operaciones descargar pdf (Pagina 239)

TM 5-4310-452-14

4-90. UNLOADER VALVE ASSEMBLY REPLACEMENT.

THIS TASK COVERS

a. Removal b. Installation

INITIAL SETUP

Equipment Conditions: Materials/Parts:

• Engine off, • Rag (Item 11, Appendix E)

• Left and right door assemblies open. • Two gaskets

• Engine and compressor air cleaner filter elements

removed (see paragraph 3-4). Tools/Test Equipment:

• Engine air cleaner assembly removed (see • General mechanic's tool kit

paragraph 4-16).

• Compressor air cleaner assembly removed (see

paragraph 4-89).

• Air lines and fittings removed (see para-

graph 4-98).

a. REMOVAL

1. Remove hose (11) from fittings (8 and 13).

2. Unscrew fittings (8 and 13) from unloader valve (4).

3. Remove hose assembly (1) and elbow (2) from unloader valve (4).

4. Remove 4 nuts (3), unloader valve (4), and gasket (12) from compressor housing (10). Discard gasket.

CAUTION

Ensure that intake hole is covered to prevent dust and debris from entering compressor. Dust

and debris can cause internal damage to the compressor.

5. Cover intake hole (9) in compressor housing (10) with a rag.

6. Remove 4 capscrews (7), shaft collar (6), and gasket (5) from unloader valve assembly (4). Discard gasket.

b. INSTALLATION

1. Install shaft collar (6), new gasket (5), and 4 capscrews (7) on unloader valve (4).

2. Remove rag from intake hole (9) and position new gasket (12) and unloader valve (4) in place on compressor

housing (10).

3. Install 4 nuts (3). Tighten nuts to 96 Ib.-ft, (130 Nom.)

4. Install hose assembly (1) and elbow (2) on unloader valve (4).

5. Install fittings (8 and 13) in unloader valve (4.). Install hose (11) on fittings.

4-182

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 404 405

Sin comentarios

MAC TOOLS MW250 Instrucciones de operaciones Pagina 239