MAC TOOLS MW250 Instrucciones de operaciones descargar pdf (Pagina 147)

100

101

TM 5-4310-452-14

4-42. BELT BREAK SWITCH REPLACEMENT.

This Task Covers:

a. Inspection c. Installation

b. Removal

Initial Setup:

Equipment Conditions: Tools/Test Equipment:

• Engine off. • General mechanic's tool kit

• Battery cables disconnected (see paragraph • Multimeter

4-57).

• Left and right door assemblies open.

a. INSPECTION

1. Remove 2 wire leads (4) from belt break switch (3).

2. Using multimeter, test continuity and function of belt

break switch (3).

b. REMOVAL

1. Remove nut (1) and belt break switch (3) from

retainer (2).

NOTE

If retainer is damaged or must be

removed for access, perform step 2.

2. Remove bolt (5), nut (6), and retainer (2) from

engine.

c. INSTALLATION

NOTE

If retainer was removed, perform step 1. If not, go to step 2.

1. Position retainer (2) in place on engine and install nut (6) and bolt (5).

2. Position belt break switch (3) through hole in retainer (2). Install nut (1) on belt break switch.

3. Install 2 wire leads (4) on belt break switch (3).

FOLLOW-ON TASKS:

• Connect battery cables (see paragraph 4-57).

• Close left and right door assemblies.

TA505472

4-85

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 404 405

Comentarios a estos manuales

Sin comentarios

MAC TOOLS MW250 Instrucciones de operaciones Pagina 147

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura MAC TOOLS MW250