MAC TOOLS MW250 Instrucciones de operaciones descargar pdf (Pagina 36)

100

101

TM 5-4310-452-14

Table 2-1. Operator Preventive Maintenance Checks and Services (PMCS).

B-Before D-During A-After W-Weekly

Interval ITEM TO BE INSPECTED Equipment is

Item PROCEDURE: Check for and have repaired Not Ready

No. B D A W filled or adjusted as needed Available If:

NOTE

• Perform these checks in the order listed,

within the designated interval, as you walk

around the compressor unit.

• Perform Before (B) and Weekly (W) PMCS if:

a. You are the assigned operator and have

not operated the compressor unit since

the last weekly check.

b. You are operating the compressor for the

first time.

• If the compressor unit must be kept in

continuous operation, check and service

only those items that will not disturb

operation. Complete the remaining checks

and services when the unit can be shut

down,

1 VEHICLE EXTERIOR

• a. Check for fluid leakage or appearance of fluid Any Class III leaks are found.

leakage,

• b. Visually check for damaged piping or hoses, and Piping or hoses are leaking or

loose, missing, or damaged parts. broken. Parts are missing or

damaged.

• c. Operate lights.

• d. Leveling jacks operate properly. If leveling jacks

are missing or damaged, notify your supervisor.

2 TIRES

• Check for excessive wear, cuts, cracks, abrasions,

and low or flat tires. Ensure that tires are inflated to

60 psi (448 kPa).

3 FUEL/WATER SEPARATOR

• • Check for water in sightbowl. If water is visible, ser- Two or more tires are flat or

vice fuel/water separator (see paragraph 3-6). missing.

4 FUEL TANK LEVEL

• Check fuel level on fuel level gage. Fuel tank is empty.

2-9

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 404 405

MAC TOOLS MW250 Instrucciones de operaciones Pagina 36

Comentarios a estos manuales

MAC TOOLS MW250 Instrucciones de operaciones Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura MAC TOOLS MW250