MAC TOOLS MW250 Instrucciones de operaciones descargar pdf (Pagina 364)

100

101

TM 5-4310-452-14

5-38. COMPRESSOR COUPLING AND MOUNTING REPAIR (Con't).

CAUTION

Dimension in step 4 must be observed when tightening screws to prevent damage to engine

crankshaft.

4. Tighten screws (1) evenly, until outside face of coupling (3) is 2.06 in. (52.34 mm) from mounting flange (7) of

gear case (8).

WARNING

Compressed air used for cleaning or drying purposes, or for clearing restrictions, should never

exceed 30 psi (207 kPa). Wear protective clothing (goggles/shield, gloves, etc. ) and use caution

to avoid injury to personnel.

5. Remove plug (9) from gear case (8) and pressure test compressor by injecting 100 psi (689.5 kPa) of

compressed air.

6. Check all gaskets for evidence of leaks.

7. Install plug (9) in gear case (8).

FOLLOW-ON TASKS:

• Install compressor on engine (see paragraph 5-35).

TA505614

5-94

1 2 ... 359 360 361 362 363 364 365 366 367 368 369 ... 404 405

Comentarios a estos manuales

Sin comentarios

MAC TOOLS MW250 Instrucciones de operaciones Pagina 364

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura MAC TOOLS MW250