MAC TOOLS MW250 Instrucciones de operaciones descargar pdf (Pagina 343)

100

101

TM 5-4310-452-14

5-31. ROOF ASSEMBLY REPLACEMENT.

This Task Covers:

a. Removal b. Installation

Initial Setup:

Equipment Conditions: Tools/Test Equipment:

• Engine off. • General mechanic's tool kit

• Protective cap assembly removed (see para-

graph 4-30). Personnel Required: Two

• Left and right door assemblies removed (see

paragraph 5-28).

• Access door removed (see paragraph 5-28).

• Front end panel assembly removed (see para-

graph 4-82).

• Right front panel removed (see paragraph 5-30).

• Roof side support and doorstops removed (see

paragraph 5-34).

1. Remove 6 screws (5) from rear wall baffle (4) and roof assembly (9).

2. Remove 4 screws (3) from roof assembly (9) and front end panel assembly (2).

3. Remove roof assembly (9) from trailer.

4. Remove 2 screws (1), nuts (7), and air deflector (6) from roof assembly (9).

5. Inspect fiberglass panel (8) and replace if necessary (see paragraph 5-33).

b. INSTALLATION

1. Position air deflector (6) in place on roof assembly (9) and install 2 screws (1) and nuts (7).

2. Position roof assembly (9) in place on trailer,

3. Install 4 screws (3) in front end panel assembly (2) and roof assembly (9).

4. Install 6 screws (5) in rear wall baffle (4) and roof assembly (9).

5-72

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 404 405

Comentarios a estos manuales

Sin comentarios

MAC TOOLS MW250 Instrucciones de operaciones Pagina 343

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura MAC TOOLS MW250