MAC TOOLS MW250 Instrucciones de operaciones descargar pdf (Pagina 272)

TM 5-4310-452-14

Section XVI. PREPARATION FOR STORAGE OR SHIPMENT

Paragraph Page

Number Title Number

4-104 Preservation ............................................................................................. ....................... 4-215

4-105 Preparation for Shipment ............... ............................................... .................................. 4-215

4-104. PRESERVATION.

a. General. If the unit is to be secured for a lengthy period of time, you must take preservation measures, The

instruction in this manual and the instructions for special administrative storage found in TM 740-90-1 will enable you to

properly preserve this compressor unit during an extended storage period.

b. Engine Preservation. To preserve the engine for storage, perform the following:

(1) Clean the outside of the engine with a reliable detergent or diesel fuel.

CAUTION

The anticorrosive oils used should conform to MIL-C-21260 or TL 9150-037/2 specifications or

NATO Code C 640/642.

(2) Drain the oil from the sump, while the engine is still hot, and fill with an anticorrosive oil.

(3) Drain the fuel from the tank into a container. Mix it with a 10% anticorrosive solution and pour back into

the tank. An alternative is to fill the tank with an injection pump testing oil that has corrosion inhibiting properties, for

example, Calibration Fluid B.

(4) Run the engine for about 10 minutes. This will fill the pipes, filter, pump, and nozzles with the preservative

mixture, (5) Stop the engine. Remove the valve covers and injection pump covers, and spray the rocker chambers and

the pump chambers with the preservative mixture. Install the valve covers.

(6) Turn the engine over several times by hand. This will spray the mixture into the combustion chamber.

(7) Close the intake and exhaust openings tightly.

NOTE

Make a list of all the preservative measures you take and place the list in the manual holder.

These preservative measures will protect the engine for a period of six to twelve months,

depending on weather and locale.

4-105. PREPARATION FOR SHIPMENT.

a. General. This unit can be transported by three different methods: 1 ) Towed by a vehicle, 2) By aircraft, railcar,

or flatbed, or 3) External air transport by helicopter.

b. Towing. See paragraphs 2-15, 2-16, and TM 9-2320-272-10.

c. Transport by Aircraft, Railcar, or Flatbed. These three types of transportation are similar because in each

circumstance the trailer must be maneuvered up a ramp and secured to the flat surface on which it rests.

(1) Maneuver the trailer up the ramp and into its final resting place.

4-215

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 404 405

Sin comentarios

MAC TOOLS MW250 Instrucciones de operaciones Pagina 272